Tough Toys Universal 4WD & Caravan Rear License Plate Relocation Bracket

Can't find a suitable place for the number plate (license plate, registration plate) after installing and after market bumper?  This relocation bracket allows you to stay legal and roadworthy by positioning your number plate up on the spare tyre. Also suitable for Caravans, trailers and swing away rear bumpers. 

The Tough Toys - License Plate Relocation Bracket allows you to position your number plate to the spare tyre carrier on your vehicle, trailer or caravan. This is required when fitting an aftermarket bumper with wheel carrier arms to a range of 4WD vehicles or any aftermarket rear bumper to a 2007-2019 Jeep Wrangler JK. Additional wiring is required to connect the included number plate lamp to the existing wiring of your vehicle or trailer. Rear number plate lamp included is 12v only and ADR & ECE Compliant (48/00).

This product is suitable for caravan owners and manufacturers who do not wish to drill holes in the rear wall of their caravan.  It enables caravan owners to mount the number plate legally to the caravan spare tyre on the rear of the caravan or camper trailer.

Features:

• ADR Compliant LED Number plate lamp included
• Suits vehicles with 5x150, 5x139.7, 5x127, 5x114.3, 6x114.3, 6x127 and 6x139.7mm Stud Pattern
• Tested with up to 35" tyres and adjustable bracket allows large offset rims
• Suits all 5 stud Jeep, 5 stud Nissan Patrol, 5 stud Toyota, 5 stud Suzuki, 6 stud Mitsubishi Pajero and Toyota Landcruiser with 6 studs
• All hardware included
• Mounts on any tyre carrier including factory ones with 3 studs
• Australian made from tough powder coated 3mm steel

Suits the following vehicles:

• Jeep Wrangler JK & TJ and earlier
• Toyota Landcruiser
• Toyota Landcruiser Prado
• Nissan Patrol GU & GQ, Navara and other models
• Suzuki Jimny
• Mitsubishi Pajero (all 6 stud models) & Triton and other models
• Ford Ranger & F150
• Caravans, trailers & campers with spare wheel carrier on the back

*Always check PCD against list above or ask us about fitment before purchasing.

*Wheel center cap hole MUST be 50mm or larger for bracket to protrude through.

*Some custom wiring may be required to relocate number plate wiring to the spare wheel. (See installation instructions below for more detail).

*Number plate bracket has been designed and tested to be compatible with the Jeep JK Wrangler AEV Rear Tyre Carrier including Fuel Caddy.

Install difficulty 1/10

Install time 30 min

IP Australia certified registered design